N UFLO™ MC-II™ Flow Analyzer CE-Approved QuickStart Mount the MC-II Direct Mount (For remote mount instructions, see the MC-II User Manual.) 1. Plug the MC-II cable connector into the pickup and turn the swivel nut clockwise until the connector is fully inserted into the pickup and the swivel nut is hand-tight. 2. Loosen the locking screws that secure the base MC-II mount. 3. MC-III™ EXP Flow Analyzer Section 1 Section 1—Introduction The NuFlo™ MC-III™ EXP Flow Analyzer (Figure ) packs a full spectrum of gas and liquid measurement functionality, high-speed performance, and log archive and retrieval capabilities in an easy-to . The MC-RTU flow analyzer provides continuous digital display of flow rate and total flow of liquids or gases. When combined with a NUFLO Turbine flow meter, selected. MC-II Flow Analyzer October T-1 TABLE OF CONTENTS NOMENCLATURE I. also according to the flow meter instruction manual.9/10().
MC-II flow totalizer provides separate, continuously illuminated LCD digital displays based on input from a turbine flowmeter A single lithium battery inside the device powers the unit for three to five years Together with a turbine flowmeter, the NUFLO MC-II totalizer delivers a low installed cost. The CO2 skid contains two ½" Halliburton Flow meters and a MCII+ Flow Analyzer to measure flow rates. Experimental Comparison of Rheology Models for Drilling Fluids Two Halliburton flow meters were used to measure the flow rates; one had a flow rate capacity of 50 gpm ( E m3/ s) while the other had a flow rate capacity of gpm (9. 3. Disconnect the old battery from the circuit assembly and remove the battery from the housing. 4. Mount the new battery in the housing, and connect it to the circuit assembly. 25 MC-II Flow Analyzer Circuit Assembly Replacement The circuit assembly (Part No. ) contains all of the electronic components.
The MC-RTU flow analyzer provides continuous digital display of flow rate and total flow of liquids or gases. When combined with a NUFLO Turbine flow meter, selected. MC-II Flow Analyzer October T-1 TABLE OF CONTENTS NOMENCLATURE I. also according to the flow meter instruction manual. Nuflo Mc-ii Exp Flow Analyzer User Manual. MC-III Panel Mount Flow Analyzer The NUFLO MC-III panel mount flow totalizer offers state-of-the art liquid and gas measurement with data logging and Modbus ® communications in an easy-to-use totalizer with a standard 1/4-DIN mount. With the capacity to record up to daily flow logs, hourly. N UFLO™ MC-II™ Flow Analyzer CE-Approved QuickStart Mount the MC-II Direct Mount (For remote mount instructions, see the MC-II User Manual.) 1. Plug the MC-II cable connector into the pickup and turn the swivel nut clockwise until the connector is fully inserted into the pickup and the swivel nut is hand-tight. 2. Loosen the locking screws that secure the base MC-II mount. 3.
0コメント